Wind Turbine

  • Make maintenance for the blades each year
  • Make maintenance for the blades each year
Make maintenance for the blades each yearMake maintenance for the blades each year

Make maintenance for the blades each year

  • wind turbine
  • wind generator
  • wind power turbine
  • wind power turbine maintenance
  • Product description: The wind turbine has only one moving part, the turbine its self. This is basically a large motor with blades on it to collect the wind. These items are very reliable and need a simple inspection once
  • INQUIRY

Wind Turbine Maintenance

The wind turbine has only one moving part, the turbine its self. This is basically a large motor with blades on it to collect the wind. These items are very reliable and need a simple inspection once a year. After 3 years turbine needs an overhaul as following:
a. Examine the surface of the blades carefully. If there is any air cauterization place, please repair.
b. Check all the bolts, lay antiseptic on the cauterization place.
c. Check the lubricate status of the generator, keep it in good state.
d. Check the erodibility of the surface and the inside parts of the wind turbine.
e.The tightness degree of the steel wire should also be checked.

This procedure is a general overhaul in the warranty service period. And this check will not cost much. The big models may need crane equipment in the checking.


The 5 and 10 years’ overhaul needs to disassemble the wind turbine. Mainly check the damageable parts, such as the bearing, bolts, lumbago brush, and replace if needed.
If the wind turbine is working under the following circumstance for long time, some parts will be easily damaged:
1. Coastal area. The out parts such as the surface, the tower, may be cauterized.
2. High temperature area. The cable may be aging much more quickly.

3. Low temperature area. The cable also maybe aging quickly. The ice will attach on the blades easily and cause the imbalance.


When the wind turbine is installed in hard environmental condition, it is necessary to make maintenance

for the blades each year.

Please refer to the attached photo.
We could use A B glue to repair FRB blade.

AB glue is a fancy name for two part Epoxy glue because the are two part The Additive

and the Base or ab, basically is super glue but it as two part and they have to be mixed.

Ex poxy glue come in two types, fast setting and slow setting. The fast setting Epoxy is as

the name implies it will set in ten second or less so you better have your piece your gluingin

position before the glue sets or you never will again . Slow setting mean it will take some time

to fully set up so you can move the piece into position and allow it to fully cure or set up.



If not repair the FRB blade each year, the wind erosion will be More and more serious,

and a last, the blades are thin edges distant deformation and cracks in the ground.